Makita HW001G Instruction Manual page 9

To install the battery cartridge;
1. Pull up the locking lever, and then open the battery
cover.
1
2
Fig.1
► 1. Battery cover 2. Locking lever
2.
Align the tongue on the battery cartridge with the
slot on the machine, and then slide the cartridge until it
locks in place with a little click.
1
Fig.2
► 1. Battery cartridge
3. Close the battery cover and push it until it is
latched with the locking lever.
To remove the battery cartridge;
1.
Pull up the locking lever and open the battery
cover.
2. Pull out the battery cartridge from the machine
while sliding the button on the front of the cartridge.
3. Close the battery cover and push it until it is
latched with the locking lever.
Battery check button
You can check the remaining battery capacity by press-
ing the battery check button.
1
2
Fig.3
► 1. Battery indicator 2. Battery check button
Battery indicator status
On
NOTE: The indicator lamp for remaining battery
capacity is just for a reference. The actual battery
capacity may differ depending on the usage condi-
tions or ambient temperature.
NOTE: The lamp automatically goes off after a few
seconds.
NOTE: If two battery cartridges are installed, the
battery installed on the left side is used first.
NOTE: If two battery cartridges are installed, the
machine automatically switches the battery when the
battery in use becomes empty.
NOTE: You can check the remaining battery capacity
without turning on the power switch.
9 ENGLISH
Off
Blinking
Remaining
battery
capacity
50% to 100%
20% to 50%
0% to 20%
Charge the
battery