Makita HW001G Instruction Manual page 17

4. Turn off the machine and attach the nozzle to
the trigger gun for your purpose, and then turn on the
machine to start the washing operation.
NOTE: When water is not ejected, detach the hose
assembly and strainer assembly and soak them in
water. Then reconnect them to the machine.
Fig.27
► 1. Hose assembly and strainer assembly
NOTE: If water suction does not work, it takes a long
time, or the water pressure is not enough, check the
following:
• Loosening of the hose assembly, strainer
assembly, and water hose connector.
• Coupling sleeves of the hose assembly are
firmly attached onto the water hose connector
and filter case of the strainer assembly.
Tighten if they are loose.
Hose assembly
1
Fig.28
► 1. Coupling sleeve
1
1
Strainer assembly
1
Fig.29
► 1. Hose band 2. Filter case
Water hose connector
Fig.30
► 1. Water hose connector
After use
CAUTION:
After operating the high pressure
washer, always perform the procedure described
in this manual. Residual pressure in the trigger gun
or high pressure washer can cause personal injury or
damage to the pump inside.
1. Turn off the machine, and remove the nozzle from
the trigger gun.
2.
Close the faucet and disconnect the water hose
from the high pressure washer.
Fig.31
3. Switch on the high pressure washer again.
17 ENGLISH
1
1
2