Makita HW001G Instruction Manual page 16

6. Attach the nozzle to the trigger gun for your pur-
pose, and then turn on the machine to start the washing
operation.
When you suspend the operation, you can temporarily
place the trigger gun as shown in the figure.
Fig.24
Supplying water from a tank/
reservoir
CAUTION:
When attaching the sleeve to the
filter case of the strainer assembly, be careful not
to hurt your hand by the hose band.
NOTICE:
Always use Makita's hose assembly
and strainer assembly.
NOTICE:
Always keep 1.0 m or less in height
between the inlet of the high pressure washer
and the water surface. Otherwise, the high pressure
washer will be unable to take the water up into the
pump.
NOTICE:
The water level that the machine can
pump up is 100 mm or more.
NOTICE:
Do not use water from rivers, ponds,
or water mixed with sand or mud. Doing so may
cause malfunction.
NOTE: If it takes a long time for the water to come
out, clean the strainer and the filter of the strainer
assembly.
You can supply water from a tank or reservoir instead
of a faucet.
1. Turn off the machine, and remove the nozzle from
the trigger gun.
2. Connect the hose assembly and strainer assembly
to the water hose connector.
2
Fig.25
► 1. Tank/reservoir 2. Strainer assembly 3. Hose
assembly 4. Water hose connector
3. Turn on the machine, and unlock the stopper and
squeeze the trigger. Once water is ejected stably from
the trigger gun, release the trigger.
1
Fig.26
► 1. Trigger gun
NOTE: It takes about 10 to 60 seconds for the water
to come out.
NOTE: Be sure to remove the nozzle from the trigger
gun before performing this operation.
16 ENGLISH
3
1
4