Makita HW001G Instruction Manual page 11

Power switch
WARNING:
Always turn off the main power
switch when not in use.
NOTICE:
Do not turn the power switch forcibly.
This may cause the switch to malfunction.
To turn on the machine, turn the power switch clock-
wise, and to turn off the machine, turn the power switch
counterclockwise.
1
Fig.6
► 1. Power switch
NOTE: The battery indicators will light up for a few
seconds just after turning the machine on.
NOTE: If you install the battery cartridge to the
machine when the power switch is in the turned-on
position, the speed indicator blinks in green. Turn
the power switch to the turned-off position, and then
install the battery cartridge to the machine.
Nozzle functions
NOTE: The standard nozzles may vary depending on
the country. Refer to the section for optional accesso-
ries for other nozzles.
Cyclone jet nozzle
Country specific
NOTICE:
Do not use the cyclone jet nozzle to
clean fragile surfaces such as windows or car
bodies.
Fig.7
A spiral jet is ejected. Suitable for removing stubborn
dirt.
Vario spray nozzle and extension
Country specific
CAUTION:
Install only the vario spray noz-
zle to the extension. Do not connect the other
optional extensions to the original extension.
Using any attachments other than those recom-
mended by the manufacturer may cause a risk of
damage or injury to persons.
CAUTION:
When adjusting the jet pressure,
do not rotate the nozzle while pulling it toward the
trigger gun. The nozzle may come off from the trig-
ger gun and cause a personal injury.
CAUTION:
When rotating the tip of the nozzle
to adjust the water jet, do not rotate it forcibly.
Otherwise, the nozzle may break and cause an injury.
1
Fig.8
► 1. Vario spray nozzle 2. Extension
Jet pressure can be adjusted by rotating the nozzle.
NOTICE:
When turning the nozzle, do not hold
the tip of the nozzle, but hold the root of the noz-
zle as shown in the figure.
Fig.9
NOTE: The vario spray nozzle can also be directly
attached to the trigger gun.
11 ENGLISH
2