Stability' Of The Machine; Chip Discharge Slot And Suction Mouth; Periodically Check That The Slot Is Not Blocked By Chips - SAINT-GOBAIN Norton Clipper CWT 315 Operating Instructions Manual

VERS. 2022.10.14

6.6 STABILITY' OF THE MACHINE

If you have to make cuts on large panels, it is
necessary to place special sliding supports next
to the machine and fix the machine itself on two
large axes sp. 50 mm with a length of 3 meters,
in order to avoid the risk of overturning due to the
cantilevered weight of the panel to be cut.

6.7 CHIP DISCHARGE SLOT AND SUCTION MOUTH

The machine is equipped with a Ø 80mm suction mouth for connecting an aspirator
(a Fig.23A).
When using the suction it is always necessary to close the slot by means of the closure
(b Fig.23B) by acting on the two knobs.
IMPORTANT:
When the aspirator is not connected, the slot must be opened by lifting the closure (b
Fig.23B) by acting on the two knobs.

Periodically check that the slot is not blocked by chips.

28
CWT 315_MAN_EN
Fig. 22