Table of Contents
Advertisement
VERS. 2022.10.14
5.2
INSTRUCTIONS FOR USING THE ELECTRICAL EQUIPMENT
Please observe the following warnings:
Do not operate the appliance if the power cable, motor cable or switch show
visible damage.
Turn off the switch before carrying out any maintenance, adjustment or repair
work and unplug the power cord from the socket. Wait until the blade has
completely stopped.
GICs equipped with an electronic brake maintain voltage on the motor even
after it has been switched off.
- Check it out the power cord before connecting. Incorrect connections can
cause the destruction of the electrical system.
- Observe the mains voltage. The data indicated on the motor identification
plate must correspond to the data of the electrical network.
- Only connect electronic equipment to a power cord with sufficient overload
protection.
In the event of a prolonged break from work without the operator being absent
or if the machine is switched off, the plug of the power supply cable must be
removed from the socket (main switch function).
- Connecting the GIC to the motor can only be done by a qualified specialist.
In the event of a power failure, the electric brake does not work. Therefore, the
machine cannot be put into operation without an operator. Do not insert your
hands into the danger zone.
Avoid short switching cycles. The high thermal stress that occurs in the event of
frequent starting and braking operations can damage the motor. The switch and
the
electronic brake.
For the mod. single phase:
- Please note that use is not continuous, therefore the machine must be used
in alternating times: 10 minutes of work and 15 minutes of pause.
Operation with a generator is not recommended in principle. Strong voltage
fluctuations and spikes are a particular danger to switches that contain
electronic components.
We decline all responsibility for damage caused by failure to comply with
what specified above.
Explanation of terms:
GIC = plug switch assembly
= failure to comply with the warning can cause damage to people
20
and the machine as well as material damage.
CWT 315_MAN_EN
Advertisement
Table of Contents
