Sweep Type - HP E4915A User Manual

■>. Press MAX :nnnnxmW and use keys on the ENTRY murk to eniei
the sweep stop (maximum) value.
■ Specifying Sweep Type
1. Use or Q=rjQ to display SWEP:nnnnn . (nnnnn shows the
current setting.)
2. Press SWEP:nnnim to display the following:
Up Updown Upmin List
3. Use or to select the sweep type and press
(Enter).
m Specifying Search Start Point
L Use or f^Qto display StartP: nnnnn . (nnnnn shows the
current setting.)
2- Press StartP:nnnnn and use keys on the ENTRY block to
specify the drive level number.
■ Specifying Wait Time After Applying Power
1- Use (2=0 or Q=]r) to display WAIT:nnnnn . (nnnnn shows the
current setting.)
2. Press WAIT:nnnnn and use keys on the ENTRY block to enter
the wait time in seconds.
LEioSooV
Figure 5-3. Sweep Type
Note J
¥
Note
3b select LIST for sweep type, you need to specify the sweep list
using HP-1B commands. List sweep allows you to specify each drive
level and perform sweeg as desired. When you select LIST, "-" at
each of
iff:
,
t$|X:
,
§WEf
: , and
:|tf
: .
You can specify the following in the DLD measurement mode as in the
crystal measurement mode.
■ Measurement parameters
n Thrget phase angle
■ Cl for determining drive level
Applications 5-15