Advertisement
3
WORK
3.1
Removing the passenger seat
3.2
Mounting the passenger seat
3.3
Recharging the battery
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
Avoid contact with battery acid and battery gases.
–
Keep sparks and open flames away from the battery. Only charge in well-ventilated rooms.
–
In the event of skin contact, rinse with large amounts of water. If battery acid gets in the eyes, rinse with water for at least
15 minutes and contact a physician.
Warning
Environmental hazard The battery contains elements that are harmful to the environment.
–
Do not dispose of batteries with the household waste. Dispose of a defective battery in an environmentally friendly manner.
Give the battery to your authorized KTM dealer or dispose of it at a collection point for used batteries.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
Even when there is no load on the battery, it discharges steadily.
The charging level and the method of charging are very important for the service life of the battery.
Rapid recharging with a high charging current shortens the battery's service life.
If the charging current, charging voltage, or charging time is exceeded, electrolyte escapes through the safety valves. This
reduces the battery capacity.
If the battery is depleted from starting the vehicle repeatedly, the battery must be charged immediately.
If the battery is left in a discharged state for an extended period, it will become over-discharged and sulfate, destroying the
battery.
The battery is maintenance-free, i.e., the acid level does not have to be checked.
–
Insert the ignition key in seat lock
–
Raise the rear of the passenger seat, push it towards the rear, and remove it
upward.
–
Remove the ignition key from the seat lock.
B00928-10
–
Hook catches
rear, and simultaneously push forward.
–
Press down the passenger seat until it clicks into place.
Warning
Danger of accidents The passenger seat can come loose from the anchoring
if it is not mounted correctly.
–
M00659-10
–
Finally, check that the passenger seat is correctly mounted.
Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the passenger seat. (
of the passenger seat onto the storage compartment, lower the
After mounting the passenger seat, check that it is locked correctly by
pulling up.
p. 5)
and turn it clockwise.
5
Advertisement
