Light Replacement - Smeg KSEG90X-1 Installation Instructions Manual

Hide thumbs

Table of Contents

These can also be washed in the dishwasher, and need to be cleaned when

all the command LEDs light up in a continuous manner or at least once

every 2 months use, or more frequently if use is particularly intensive.

Resetting the alarm signal

• Press button T1 (see the paragraph on Use).

Cleaning the Filters

• Remove the Filters one at a time, supporting them with one hand while

you pull the lever down with the other.

• Wash the Filters without bending them, and leave them to dry com-

pletely before replacing.

• Replace, taking care to ensure that the handle faces forwards.

• This cannot be washed or regenerated, and must be changed when all the command LEDs start to flash, or at least once

every 4 months.

Activating the alarm signal

• In Recirculation Version Hoods, the Filter Saturation Alarm must be activated on installation or at a later date.

• Press and hold the Delay button (T4) on the keypad for 5 seconds and the following will be displayed:

•

Leds (L1-L2-L3) flash twice – Activated Charcoal Filter saturation alarm ACTIVATED.

•

Leds (L1-L2-L3) flash once – Activated Charcoal Filter saturation alarm DEACTI VATED.

CHANGING THE ACTIVATED CHARCOAL FILTER

Resetting the alarm signal

• Press button T1 (see the paragraph on Use).

Changing the Filter

• Remove the Metal grease filters.

• Remove the saturated Activated Charcoal Filters, as indicated (A).

• Fit the new Filters, as indicated (B).

• Replace the Metal grease filters.

Halogen lamps

• Open the spotlight cover.

• Remove the halogen lamp from the lamp holder.

• Replace it with another lamp that has the same characteristics,

making sure that the two pins are inserted properly into the

housings in the lamp holder.

• Close the spotlight cover.

Metal grease filters

Activated Charcoal Filter (Recirculation Version)

Lighting