Smeg KSEG90X-1 Installation Instructions Manual page 7

USE
L
Button Function
L Turns the lighting system on and off.
Press and hold for approx. 2 seconds to turn the
lighting system on and off at reduced intensity.
T1 Turn the suction motor on and off at speed one.
Press and hold the button for approximately 2
seconds, with all the loads turned off (Motor and
Lights), to reset the Filters and turn off the Leds that
are lit.
T2 Turn the suction motor on at speed two.
Press and hold for approximately 5 seconds, with all
the loads turned off (Motor and Lights), to
enable/disable the Remote control.
T3 Turn the suction motor on at speed three.
Press and hold the button for 2 seconds to activate
intensive speed. This speed is timed to run for 10
minutes. At the end of this time the system will
automatically return to the speed set before.
T4 Press and hold the button for approximately 2
seconds to activate automatic shutdown with a 30'
delay (Motor+Lights).
Press and hold for approximately 5 seconds to
enable/disable the Activated Charcoal Filter alarm.
EN
L1 L2
T1 T2
Control panel
L3 L4
T3 T4
Led
-
-
On.
After 100 working hours all the
LEDs (L1-L2-L3-L4) will light up
and remain lit to indicate saturation
of the metal grease filters.
After 200 working hours all the
LEDs (L1-L2-L3-L4) will light up
and start to flash to indicate
saturation of the activated charcoal
filters.
On.
2 flashes, Remote control Enabled.
1 flash, Remote control Disabled.
On.
On.
2 Flashes of the Leds (L1-L2-L3)
Filter Alarm Enabled.
1 Flash of the Leds (L1-L2-L3)
Filter Alarm Disabled.
1 13