Using Watch Operations To Adjust The Time Setting - Casio 5660 Operation Manual

Using Watch Operations to
Adjust the Time Setting
If, for some reason, you cannot use time signal
reception to adjust the current time setting,
you can adjust date, time, and Home City
settings manually using watch button
operations.
Setting a Home City
●
Use the procedure in this section to select a
city to use as your Home City. If you are in an
area that observes summer time, you can also
enable or disable summer time.
1.
Enter the Timekeeping Mode.
Navigating Between Modes
l
2.
Pull out the crown.
This causes [CITY] to flash on the display
and the second hand to move to the
current Home City.
Second hand
Home City
3.
Rotate the crown to move the second
hand to the city code of the city you want
to set as your Home City.
For information about city codes, refer
●
to the information below.
City Table
l
4.
Press (B).
Watch Operation Guide 5660
5.
Rotate the crown to select a summer time
setting.
Rotating the crown cycles through the
setting items shown below.
[AUTO]
●
The watch switches between standard
time and summer time automatically.
[OFF]
●
The watch always indicates standard
time.
[ON]
●
The watch always indicates summer
time.
6.
Push the crown back in to complete the
setting operation.
Note
If you do not perform any operation for
●
about two minutes after pulling out the
crown, crown operations will
Crown
automatically become disabled. If that
happens, push the crown back in and
then pull it out again.
The [AUTO] summer time setting is
●
valid when the watch's Home City is in
an area where a time signal can be
received.
Setting the Time/Date
●
You can use the procedure below to adjust the
time and date settings when using the watch
where signal reception is not possible.
Important!
If you are using the watch in an area
●
where signal receive operations are
possible, time and date settings using
the time signal is recommended.
Configure the Home City setting before
●
changing the current time and date
settings.
Setting a Home City
l
1.
Enter the Timekeeping Mode.
Navigating Between Modes
l
2.
Pull out the crown.
This causes [CITY] to flash on the display
and the second hand to move to the
current Home City.
Second hand
Home City
3.
Press (D).
This causes [HOUR-MIN] to flash on the
display.
You can see if a time is a.m. ([A]) or p.m.
●
([P]) by checking the second hand
position.
4.
Rotate the crown to change the minute
setting.
Crown
14