Specifying A World Time City; Swapping Your Home Time And World Time; Alarm; Configuring Alarm Settings - Casio 5660 Operation Manual

Specifying a World Time City

Use the procedure in this section to select a
World Time city. If you are in an area that
observes summer time, you can also enable
or disable summer time.
1.
Enter the World Time Mode.
Navigating Between Modes
l
2.
Pull out the crown.
This causes [CITY] to flash on the display
and the second hand to move to the
current Home City.
Second hand
Home City
3.
Rotate the crown to move the second
hand to the city code of the city you want
to specify as your World Time City.
This displays the current time in the city
you select.
4.
Press (B).
This causes [ON] or [OFF] to flash on the
display.
5.
Rotate the crown to select a summer time
setting.
[OFF]
●
The watch always indicates standard
time.
[ON]
●
The watch always indicates summer
time.
6.
Push the crown back in to complete the
setting operation.
Watch Operation Guide 5660
Note
If you do not perform any operation for
●
about two minutes after pulling out the
crown, crown operations will
automatically become disabled. If that
happens, push the crown back in and
then pull it out again.
While [UTC] is selected as the city, you
●
will not be able to change or check the
summer time setting.
Specifying UTC (Coordinated Universal
●
Time) as Your World Time City
To set UTC (Coordinated Universal Time) as
your World Time City, enter the World Time
Mode and then hold down (A) for at least three
seconds.
Crown
Swapping Your Home Time
and World Time
In the World Time mode, hold down (D) for at
least three seconds until [
and your Home City time swaps places with
your World Time.
Before swapping
Home Time
World Time
The watch will beep when an alarm time is
reached. You can set up to five different
alarms. The hourly time signal causes the
watch to beep every hour on the hour.
●

Configuring Alarm Settings

1.
2.
] flashes,
After swapping
World Time
3.
Home Time
4.

Alarm

The beeper will not sound if battery power
is low.
Enter the Alarm Mode.
Navigating Between Modes
l
Use (A) and (C) to display the number
([AL1] to [AL5]) of the alarm whose
settings you want to change.
Alarm number
Alarm time
Pull out the crown.
This causes the hours and minutes digits
to flash.
Hours
Minutes
Rotate the crown to change the minute
setting.
The hour digit changes in sync with the
●
minute digit change.
Crown
16