Table of Contents
Advertisement
Chapter 1 Installing Windows
3.8.3 Removing a team
Remove a team by using the NIC teaming setup tool.
1.
In the Servers section, select the name of the server to set up.
If there is only one server connected, the name of the server is selected automatically.
2.
In the Teams section, select the team to remove.
3.
In the Teams section, under Tasks, select Delete.
4.
The message box to confirm appears, then click Delete team.
3.8.4 Notes and restrictions
NIC teaming on a guest OS is not supported.
Teaming of virtual NICs on the host OS is not supported in the Hyper-V environment.
When STP (Spanning Tree Protocol) is enabled on network switch ports to which network adapters of
the team are connected, network communications may be disrupted. Disable STP, or configure
"PortFast" or "EdgePort" to the ports.
* About setting the network switch of the connection destination, see the manual of the network switch.
All NICs in the team must be connected to the same subnet.
Teaming of different speed NICs is not supported.
Teaming of different vendor's NICs is not supported.
When teaming is configured in a Network Load Balancing (NLB) environment, you should select
multicast mode on the NLB cluster.
When a team is removed, the following error message may be logged in the system event log.
You can safely ignore this error message.
Task Category
In a Windows Server Failover Cluster environment, heartbeat interruption or failover may occur if you
configure Active-Standby teaming. To avoid this, you should configure multiple NICs in Active Mode in a
team so that all the NICs do not fail simultaneously.
68
Level
Error
Source
Microsoft-Windows-NDIS
Event ID
10317
PnP
Message
Miniport Microsoft Network Adapter Multiplexor Driver, {xxxxxxxx-xxxx-
xxxx-xxxx-xxxxxxxxxxxx}, had event Network Interface deleted while PNP Device
still exists. Note that this event is provided for informational purpose and might not
be an error always (Eg: In case of vSwitch which was recently un-installed or a
LBFO team was removed)
Installation Guide (Windows Server 2019)
3. Installing Windows Server 2019
Advertisement
Table of Contents
