Dvd Super Multi Drive - Toshiba Tecra M11-SP4002 User Manual

Problem

DVD Super Multi drive

For more information, refer to Chapter 4,
Problem
You cannot access a
CD/DVD in the drive
Some CD/DVDs run
correctly, but others
do not
User's Manual
Procedure
Check the region code on the DVD. It must
match that on the DVD-ROM. Region codes are
listed in the Optical disc drives
Chapter 2, The Grand
Operating
Procedure
Make sure the drive's disc tray is securely
closed. Press gently until it clicks into place.
Open the disc tray and make sure the CD/DVD is
properly seated. It should lie flat with the label
facing up.
A foreign object in the disc tray could block laser
light from reading the CD/DVD. Make sure there
is no obstruction. Remove any foreign object.
Check whether the CD/DVD is dirty. If it is, wipe it
with a clean cloth dipped in water or a neutral
cleaner. Refer to the
Chapter 4 for details on cleaning.
The software or hardware configuration may be
causing a problem. Make sure the hardware
configuration matches your software's needs.
Check the CD/DVD's documentation.
Check the type of CD/DVD you are using.
The drive supports:
DVD-ROM:
CD-ROM:
Recordable DVD:
Check the region code on the DVD. It must
match that on the DVD Super Multi drive. Region
codes are listed in the
in Chapter 2, The Grand
Troubleshooting
section in
Tour.
Basics.
Media care section in
DVD-ROM, DVD-Video
CD-DA, CD-Text, Photo CD
(single/multi-session),
CD-ROM Mode 1, Mode 2,
CD-ROM XA Mode 2
(Form1, Form2), Enhanced
CD (CD-EXTRA),
Addressing Method 2
DVD-R/-R DL, DVD+R/+R
DL, DVD-RW, DVD+RW,
DVD-RAM
Optical disc drives
Tour.
section
8-10