Read all instructions carefully before using the wooden infrared sauna room IG-570 BH P R E C A U T I O N S F O R U S E ............1 P A R T S N A M E S .
Page 2
ATTENTION ※Read all instructions before using this appliance. ※Serious injury may result if warnings and instructions below are not observed. ※When using an electrical appliance, basic precautions should always be followed, including the following: DANGER To reduce the risk of burns, fire, electric shock, or injury to persons. ※Connect the power cord to a properly grounded outlet only.
READ BEFORE INSTALLATION: ※ Each panel is heavy. Be careful to avoid injury when installing, especially the top panel. ※ Two adults are required for the installation of sauna room. ※ There is a “+” button or a “–” button at the sides of each panel, which will be installed correspondently with one “+”...
INSTALLATION OF SAUNA ROOM BODY 1. Place the floor panel in the desired location on a level surface (Note: The floor panel must be level before installing wall and ceiling panels. If the surface is not level you may need to shim the bottom panel to get level.) ※...
Page 6
4. Place the right side panel and the left side panel in the slot of floor panel. 5. Place the bench support panel first and then place the bench surface panel into the sauna room. ※ On larger sauna rooms with more than one bench, rotate the wooden bench supports away from the side walls.
Page 7
6. Place the front panel in the slot of floor panel, then lock the two inside latches between front and right side panel and between front and left side panel. 7. Place the top panel on the five side panels. Make sure the connection wires of three side panels (left back, right back &...
Page 8
WARNING: ELECTRIC SHOCK HAZARD Do not plug cord into electrical outlet before connecting power cord wires to terminal block. 9. Make sure to connect wires in correct location by matching color to correct screw location: ※ Open cover on top side of ceiling panel to see three unconnected power wires (Picture 1) ※...
CONTROL PANEL INSTRUCTION 1.Press “POWER”to switch on or off. 2.“TIME”refers to control of operating time and indicates the amount of time remaining. ※Once power is on, the default amount of operating time is at 45 minutes. ※Press “UP” and “DOWN” to adjust and set time of use; pressing once will increase or reduce in 5 minute increments.
OPERATING INSTRUCTIONS FOR COLOR LIGHT THERAPY SYSTEM 1. To activate the color light therapy system press “ADJUST” on the sauna control panel. Upon turning the system on, the color light system will go into an automatically cycling mode, changing color every 8 seconds: 2.
WARNINGS AND SUGGESTIONS FOR USE Please read carefully the following warnings, to reduce the risk of burns, fire, electric shock, or injury to persons: ※Do not put the sauna room in a moist environment. ※Place room on level surface. ※Do not repair the product by yourself. Contact the Saunatec National Customer Service Center toll-free at 1-888-780-4427, or email at techsupport@saunatec.com ※Do not disassemble the product by yourself except as indicated in the manual.
Need help?
Do you have a question about the IG-570 BH and is the answer not in the manual?
Questions and answers