Table of Contents
Advertisement
Display
Basic setting
Telescopic shelves retrofitted
Automatic rapid heating from 200 °C
Reset all values to factory settings
..
Home Connect Settings
1
Factory setting (may vary according to model)
Depending on the appliance specifications
2
11.2 Changing basic settings
Requirement: The appliance is switched off.
Press and hold
for approx. 4 seconds.
1.
Change the basic setting via the settings area.
2.
3.
Press
to confirm.
a The next basic setting appears on the display.
Use
to navigate to the next basic setting.
4.
To save the changes, press and hold
5.
4 seconds.
Home Connect
12 Home Connect
This appliance is network-capable. Connecting your ap-
pliance to a mobile device lets you control its functions
via the Home Connect app, adjust its basic settings
and monitor its operating status.
The Home Connect services are not available in every
country. The availability of the Home Connect function
depends on the availability of Home Connect services
in your country. You can find information about this at:
www.home-connect.com.
The Home Connect app guides you through the entire
login process. Follow the instructions in the Home Con-
nect app to configure the settings.
Tips
¡ Please consult the documents supplied by
Home Connect.
¡ Please also follow the instructions in the Home Con-
nect app.
Notes
¡ Please note the safety precautions in this instruction
manual and make sure that they are also observed
when operating the appliance via the Home Con-
nect app.
→ "Safety", Page 2
¡ Operating the appliance on the appliance itself al-
ways takes priority. During this time it is not possible
to operate the appliance using the Home Connect
app.
¡ In networked standby mode, the appliance requires
a maximum of 2 W.
Selection
2
= no
= yes (for 2- and 3-level pull-out)
2
= no
= yes
= no
= yes
→ "Home Connect ", Page 17
Note: Your changes to the basic settings will be re-
tained even after a power failure.
11.3 Discarding changes to the basic
settings
▶
a All changes are discarded and not saved.
for approx.
12.1 Setting up Home Connect
Requirements
¡ The appliance is connected to the power supply and
¡ You have a mobile device with a current version of
¡ The mobile device and the appliance are within
1.
2.
3.
1
(for rails and 1-level pull-out)
1
1
Touch
.
is switched on.
the iOS or Android operating system, e.g. a smart-
phone.
range of your home network's Wi-Fi signal.
Download the Home Connect app.
Open the Home Connect app and scan the follow-
ing QR code.
Follow the instructions in the Home Connect app.
Home Connect en
17
Advertisement
Chapters
Table of Contents
