Interlogix Simon XTi-5 User Manual page 25

Condition
Restoration of power
Sensor failure
Sensor low battery
Failure to communicate
Sensor open
Sensor tampered
RF jam detected
Clearing status
Simon XTi-5 User Manual
Description
This condition occurs after a complete loss of power (AC and
battery). When power is restored, the panel will return to the
arming state with the same zones bypassed it had prior to losing
power.
This condition occurs if a sensor is not communicating with the
panel. Trouble beeps will start. You may need to call your security
system dealer if the problem continues.
This condition occurs if a system sensor has a low battery. The
sensor may still be communicating with the panel. Trouble beeps
will start. Press and then press
SETTINGS menu. The panel will speak which sensors have low
battery. You may need to call your security system dealer to
resolve this problem. Some sensor batteries can be replaced by
the homeowner.
This condition occurs if your security system could not
communicate successfully to the central monitoring station. Your
system will try to report to the central monitoring station eight
times before it tells you there is a fail-to-communicate problem.
Trouble beeps will start and the yellow triangle appears over the
settings icon. You may need to call your security system dealer if
the problem continues.
This condition occurs if a door or window is open or a system
sensor has been disturbed and not reset properly. For example, a
door/window sensor magnet may have been removed from the
sensor. Your system will indicate this condition to you by
displaying a red SENSOR OPEN icon (see Table 4 on page 4)
and show the icon in the bottom right of the main screen.
Correct the problem by resetting the sensor. If this condition
continues, call your security system dealer.
This condition occurs when a sensor is physically tampered with,
for example, that the cover is taken off one of the sensors. If the
system is armed, an alarm will occur and the red alarm pop-up
appears. If the system is disarmed, the Sensor icons change to
red (see Table 4 on page 4),
beeps will start. Correct the problem by resetting the sensor. If
this condition continues, call your security system dealer.
The panel receiver may be experiencing some interference. The
system will call to notify the central monitoring station about this
problem.
Some types of status conditions, such as alarm history, must be
cleared manually. To clear system status, press CLEAR next to
Panel Status in the STATUS & SETTINGS menu. If the trouble
condition was a low system battery, perform a sensor test. The
should disappear if all trouble conditions have been corrected.
in the STATUS &
icon appears, and Trouble
19