Table of Contents
Advertisement
Safety Information
Safety Information
• After completing the installation, always carry out a
functional test and provide the instructions on how to
operate the air conditioner to the user.
• Do not use the air conditioner in environments with
hazardous substances or close to equipment that release
free flames to avoid the occurrence of fires, explosions or
injuries.
• Our units should be installed in compliance with the spaces
shown in the installation manual, to ensure accessibility
from both sides and allow repairs or maintenance
operations to be carried out. The unit's components should
be accessible and easy to disassemble without endangering
people and objects.
For this reason, when provisions of the installation manual
are not complied with, the cost required to access and repair
the units (in SAFETY CONDITIONS, as set out in prevailing
regulations) with harnesses, ladders, scaffolding or any
other elevation system will NOT be considered part of the
warranty and will be charged to the end customer.
Power supply line, fuse or circuit
breaker
WARNING
• Always make sure that the power supply is compliant with
current safety standards. Always install the air conditioner in
compliance with current local safety standards.
• Always verify that a suitable grounding connection is
available.
• Verify that the voltage and frequency of the power supply
comply with the specifications and that the installed power
is sufficient to ensure the operation of any other domestic
appliance connected to the same electric lines.
• Always verify that the cut-off and protection switches are
suitably dimensioned.
• Verify that the air conditioner is connected to the power
supply in accordance with the instructions provided in the
wiring diagram included in the manual.
• Always verify that electric connections (cable entry, section
of leads, protections...) are compliant with the electric
specifications and with the instructions provided in the
wiring scheme. Always verify that all connections comply
with the standards applicable to the installation of air
conditioners.
4
English
• Devices disconnected from the power supply should be
completely disconnected in the condition of overvoltage
category.
• Be sure not to perform power cable modification, extension
wiring, and multiple wire connection.
– It may cause electric shock or fire due to poor connection,
poor insulation, or current limit override.
– When extension wiring is required due to power line
damage, refer to Step 13 Optional: Extending the power
cable in the installation manual.
CAUTION
Make sure that you earth the cables.
• Do not connect the earth wire to the gas pipe, water pipe,
lighting rod or telephone wire. If earthing is not complete,
electric shock or fire may occur.
Install the circuit breaker.
• If the circuit breaker is not installed, electric shock or fire
may occur.
Make sure that the condensed water dripping from the
drain hose runs out properly and safely.
Install the power cable and communication cable of
the indoor and outdoor unit at least 1m away from the
electric appliance.
Install the indoor unit away from lighting apparatus
using the ballast.
• If you use the wireless remote control, reception error may
occur due to the ballast of the lighting apparatus.
Advertisement
Table of Contents
