Replacing The Power Cable; Disposal And Recycling; Cleaning, Maintenance And Ordering Of Spare Parts - Alpha tools PS 600 E Original Operating Instructions

Anleitung_PS_600_E_SPK7:_
Replace blunt, bent or cracked saw blades
immediately.
Place the saw foot flat on the workpiece you wish to
saw. Switch on the jigsaw.
Allow the saw blade to accelerate until it reaches full
speed. Then slowly move the saw blade along the
cutting line. Only exert gentle pressure on the saw
blade as you do so.
When cutting metal, apply a suitable coolant along
the line you wish to cut.
6.6 Sawing out sections (Fig. 10)
Drill a 10 mm hole in the section you wish to saw out.
Insert the saw blade into this hole and start to saw out
the required section.
6.7 Making parallel cuts
Mount the parallel stop and adjust as required (see
section 5.3).
Observe the instructions in section 6.5.
Cut as shown in Figure 11.
6.8 Making miter cuts
Set the angle on the soleplate (see section 5.4).
Observe the instructions in section 6.5.
Cut as shown in Figure 12.

7. Replacing the power cable

If the power cable for this equipment is damaged, it
must be replaced by the manufacturer or its after-sales
service or similarly trained personnel to avoid danger.
8. Cleaning, maintenance and ordering of
spare parts
Always pull out the mains power plug before starting
any cleaning work.
8.1 Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts of
the equipment. Ensure that no water can seep
into the device.
8.2 Carbon brushes
In case of excessive sparking, have the carbon
26.08.2011 8:18 Uhr Seite 15
brushes checked only by a qualified electrician.
Important! The carbon brushes should not be rep
laced by anyone but a qualified electrician.
8.3 Maintenance
There are no parts inside the equipment which
require additional maintenance.
8.4 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info

9. Disposal and recycling

The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material and
can therefore be reused or can be returned to the raw
material system.
The unit and its accessories are made of various types of
material, such as metal and plastic. Defective
components must be disposed of as special waste. Ask
your dealer or your local council.
10. Storage
Store the equipment and accessories out of children's
reach in a dark and dry place at above freezing
temperature. The ideal storage temperature is between
5 and 30 °C. Store the electric tool in its original
packaging.
GBR
15