Replacing The Power Cable; Disposal And Recycling; Cleaning, Maintenance And Ordering Of Spare Parts - Alpha tools DF 850 Original Operating Instructions

Anleitung_DF_850_SPK7:_
GB
7.3 Positionin the biscuit jointer (Fig. 7/8)
Set and check the cutting depth.
Set the angle fence (11).
Set the height.
Position the machine near to the workpiece.
There are markings (20) on the machine; these
must line up with the line you have drawn.
Now switch on the machine and push the drive
motor (12) forwards. The workpiece must be se-
curely clamped.
7.4 Connecting the workpieces (Fig. 9/10)
When you have cut a slot on both workpieces they
can be connected.
Place glue in both slots.
Insert the biscuit dowel (a) into one of the slots
(Fig. 9).
Press both workpieces together (Fig. 10).
Clamp the workpieces and wait until the glue has
set.

8. Replacing the power cable

If the power cable for this equipment is damaged, it
must be replaced by the manufacturer or its after-
sales service or similarly trained personnel to avoid
danger.
9. Cleaning, maintenance and ordering
of spare parts
Always pull out the mains power plug before starting
any cleaning work.
9.1 Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts
of the equipment. Ensure that no water can seep
into the device.
9.2 Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a qualified electrician.
Important! The carbon brushes should not be rep
laced by anyone but a qualified electrician.
12
07.10.2009 10:51 Uhr Seite 12
9.3 Maintenance
There are no parts inside the equipment which
require additional maintenance.
9.4 Ordering replacement parts
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices, information and order details
please go to www.isc-gmbh.info

10. Disposal and recycling

The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.