Sound And Vibration; Before Starting The Equipment - Alpha tools PS 600 E Original Operating Instructions

Anleitung_PS_600_E_SPK7:_

Sound and vibration

Sound and vibration values were measured in
accordance with EN 60745.
L sound pressure level
pA
K uncertainty
pA
L sound power level
WA
K uncertainty
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 60745.
Cutting wood
Vibration emission value a = 7,76 m/s 2
h
K uncertainty = 1,5 m/s 2
Cutting sheet metal
Vibration emission value a = 4,96 m/s 2
h
2
K uncertainty = 1,5 m/s
Additional information for electric power tools
Warning!
The specified vibration value was established in
accordance with a standardized testing method. It may
change according to how the electric equipment is used
and may exceed the specified value in exceptional
circumstances.
The specified vibration value can be used to compare
the equipment with other electric power tools.
The specified vibration value can be used for initial
assessment of a harmful effect.
Keep the noise emissions and vibrations to a
minimum.
Only use appliances which are in perfect working
order.
Service and clean the appliance regularly.
Adapt your working style to suit the appliance.
Do not overload the appliance.
Have the appliance serviced whenever necessary.
Switch the appliance off when it is not in use.
Wear protective gloves.
26.08.2011 8:18 Uhr
Residual risks
Even if you use this electric power tool in accordance
with instructions, certain residual risks cannot be
rules out. The following hazards may arise in
connection with the equipment's construction and
layout:
86.4 dB(A)
1. Lung damage if no suitable protective dust mask is
3 dB used.
2. Damage to hearing if no suitable ear protection is
97.4 dB(A)
used.
3 dB
3. Health damage caused by hand-arm vibrations if
the equipment is used over a prolonged period or is
not properly guided and maintained.

5. Before starting the equipment

Before you connect the equipment to the mains supply
make sure that the data on the rating plate are identical
to the mains data.
Always pull the power plug before making adjustments
to the equipment.
5.1 Safety guard (Fig. 1/Item 15)
The safety guard (15) protects the user from
accidentally touching the saw blade (12) and
nevertheless enables you a free view of the cutting
area.
5.2 Changing the saw blade (Fig. 2/Item 12)
Important!
Pull the mains plug before you fit or replace a saw
blade.
Set the selector switch for pendulum action (8) to
position 3.
The teeth of the saw blade are very sharp!
Undo the screws (a) on the blade holder (14) using
the supplied Allen key.
Insert the saw blade (12) into the guide groove (b)
of the blade holder (14) as far as the stop.
Tighten the screws (a) with the supplied Allen key.
The teeth on the saw blade must be pointing in the
direction of cutting. Check that the saw blade is
positioned in the guide groove (b) of the blade
holder (14) and the roller.
Check that the saw blade (12) is securely mounted
in the blade holder.
Follow the instructions above in reverse order to
remove the saw blade.
Seite 13
GBR
13