Technical Data; Sound And Vibration; Before Starting The Equipment - Alpha tools AT-OF 1200 E Original Operating Instructions

Anleitung_AT_OF_1200_E_SPK7:_

4. Technical data

Mains voltage: 230 V ~ 50 Hz
Power input:
Idling speed: 11,000 – 30,000 rpm
Stroke height: 55 mm (cutting depth)
Clamp Ø 8 and Ø 6 mm
Max. for shaping router:
Protection class:
Weight:

Sound and vibration

Sound and vibration values were measured in
accordance with EN 60745.
L sound pressure level 90.3 dB(A)
pA
K uncertainty
pA
L sound power level 101.3 dB(A)
WA
K uncertainty
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 60745.
Handles
Vibration emission value a = 4.74 m/s 2
h
K uncertainty = 1,5 m/s 2
Additional information for electric power tools
Warning!
The specified vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equipment
is used and may exceed the specified value in
exceptional circumstances.
The specified vibration value can be used to compare
the equipment with other electric power tools.
The specified vibration value can be used for initial
assessment of a harmful effect.
Keep the noise emissions and vibrations to a
minimum.
Only use appliances which are in perfect working
order.
Service and clean the appliance regularly.
11.05.2010 13:25 Uhr
Adapt your working style to suit the appliance.
Do not overload the appliance.
Have the appliance serviced whenever
necessary.
1200 W Switch the appliance off when it is not in use.
Wear protective gloves.
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain residual
32 mm
risks cannot be rules out. The following hazards
II / ®
may arise in connection with the equipment's
construction and layout:
3.4 kg
1. Lung damage if no suitable protective dust mask
is used.
2. Damage to hearing if no suitable ear protection is
used.
3. Health damage caused by hand-arm vibrations if
the equipment is used over a prolonged period or
is not properly guided and maintained.
3 dB

5. Before starting the equipment

3 dB
Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Always pull the power plug before making
adjustments to the equipment.
All covers and safety devices have to be properly
fitted before the machine is switched on.
5.1 Extraction port assembly (Fig. 2-3/Item 1)
Important. For health and safety reasons it is
imperative that you use a dust extractor.
Connect your router to the extraction port (1) of a
vacuum cleaner or a dust extraction device. This
will provide excellent dust extraction on the
workpiece. The benefits are that you will protect
both the equipment and your own health. Your
work area will also be cleaner and safer.
Dust created when working may be dangerous.
Refer to the section entitled "Safety instructions".
The vacuum cleaner you use for the extraction
work must be suitable for the workpiece material.
Use a special vacuum cleaner if you are handling
harmful materials.
Press the two plastic trays (1A and 1B) together
as shown in the figure.
Secure the extraction port (1) to the routing shoe
(2) using the two countersunk screws (f).
The extraction port can be connected to extractor
units (vacuum cleaners) with a suction hose.
Seite 15
GB
15