Operation - Ryobi CSD41 User Manual

EN
FR DE ES IT NL

OPERATION

WARNING
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a
WARNING
Always wear safety goggles or safety glasses with side
shields when operating products. Failure to do so could
WARNING
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
TO CHARGE
When charging the screwdriver, a red charge light will
illuminate on the handle of the screwdriver. This red charge
light will go off when the screwdriver is fully charged.
properly connected.
Charger can be used with normal household voltage of
230V,50Hz, AC only.
Connect charger to power supply.
After normal usage, a minimum of 10-12 hours
charging time is required to fully recharge the
screwdriver.
Do not place charger in an area of extreme heat or
cold. It will work best at normal room temperature.
Remove the product from the charger once it is fully
charged and ready for use.
WARNING
Battery products are always in operating condition.
Therefore, the switch should always be locked when
not in use or carrying at your side.
ADJUSTABLE TORQUE CLUTCH
clutch for driving different types of screws into different
materials. The proper setting depends on the type of
material and the size of screw you are using.
PT DA SV FI NO RU
English
PL CS HU RO LV LT
ADJUSTING TORQUE
There are twelve torque indicator settings located on the
front of the screwdriver.
1 - 2 For driving small screws
3 - 4 For driving screws into soft material
5 - 7 For driving screws into soft and hard
materials
8 - 9 For driving screws into hard wood
10 - 11 For driving large screws
For full power applications
DIRECTION OF ROTATION SELECTOR (FORWARD/
REVERSE/CENTER LOCK)
The direction of bit rotation is reversible and is controlled
by a selector located above the switch trigger. With the
screwdriver held in normal operating position, the direction
of rotation selector should be positioned to the left of the
switch trigger for forward motion. The direction is reversed
when the selector is to the right of the switch trigger.
Setting the switch trigger in the OFF (center lock) position
helps reduce the possibility of accidental starting when not
in use.
To stop the screwdriver, release the switch trigger and
allow the collet to come to a complete stop.
INSERTING/REMOVING BIT
Insert the bit into collet until it snaps in place. Remove
the bit by pulling it out of the collet.
SPINDLE LOCK
is not pressed.
This enables screws to be screwed in, even when the
battery is empty.
GRIP ZONE
Soft grip reduces the danger of slipping and thereby
improves the grip on the tool and handing. At the same
time, the rubber coating achieves a vibration-reducing
effect.
LED WORKLIGHT
The screwdriver has a built-in LED worklight. This feature
is convenient when working in close or tight areas where
additional light is needed. Whenever the switch trigger is
3
ET HR SL SK BG UK TR EL