Operation; Stopping; Cleaning; Using The Accessory - Stiga Villa Spring Instruction Manual

(Translation of the Original Instructions)
1 . Open the fuel cock (16).
2 . Check that the spark plug cables are instal-
led on the spark plugs.
3 . Check the PTO is disengaged (12:A; 13:A).
4 . Do not keep your foot on the service/drive
brake (10:F)
Cold start
1 . Engage the transmission (14:A)
2 . Activate the parking brake (11:B)
3 . Put the choke on (where applicable) (12:D;
13:C).
4 . Turn the key in the ignition and start the en-
gine.
5 . When the engine is running, gradually acce-
lerate to maximum operating speed
Before starting work with the machine,
wait a few minutes for the oil to warm
up .
Warm start .
1 . Engage the transmission (14:A)
2 . Activate the parking brake (11:B)
3 . Turn the throttle to full on (12:D; 13:C).
4 . Turn the key in the ignition and start the en-
gine.
To proceed see the instructions provi-
ded in heading 7 .6 .1 .

7 .6 .1 Operation

To start the machine, proceed as follows:
Only for models: [Gear]
• Put into gear with the gear lever (12:B)
1 . Press the pedal (11:B) right down then rele-
ase it.
2 . Activate the pedal (13:E) to move the ma-
chine.
3 . Go to the work area.
4 . If front accessories have been installed, acti-
vate the PTO (12:A; 13:A)
5 . Commence work.
7 .7

STOPPING

To stop the machine, proceed as follows:
1 . Disengage the PTO (12:A; 13:A)
2 . Engage the parking brake (11:B)
3 . Allow the engine to idle 1-2 mins.
4 . Turn off the engine by turning the ignition
key.
5 . Close the fuel cock. This is particularly impor-
tant if the machine is to be transported on a
trailer for example.
ENGLISH
If you have to leave the machine unat-
tended, disconnect the spark plugs and
remove the key from the ignition .
The engine may be very warm immedia-
tely after it is shut off. Do not touch the
silencer, cylinder or cooling fins. This
can cause burn injuries .
7 .8

CLEANING

To reduce the risk of fire, keep the engi-
ne, silencer, battery and fuel tank free
from grass, leaves and oil
To reduce the risk of fire, regularly
check the machine for oil and/or fuel
leaks .
Never use high-pressure water jets .
This can damage shaft seals, electrical
components or hydraulic valves .
Always clean the machine after use. To clean
the machine adhere to the instructions provided
below:
• Do not spray water directly onto the engine.
• Clean the engine with a brush and/or
compressed air.
• Clean the motor cooling air intake.
• After cleaning using water, start the machine
and any cutting device assy to remove any
water which may otherwise end up in the
bearings and cause damage.

8 USING THE ACCESSORY

Make sure the grass to be cut is com-
pletely free of foreign objects such as
stones etc .
8 .1

CUTTING HEIGHT

For best results, cut off the top third of the grass.
See fig. 23.
If the grass is long and needs cutting back signifi-
cantly, cut twice using two different cutting heights.
Do not use the lowest cutting heights if the lawn
surface is uneven.
This would entail a risk of the cutting devices being
damaged against the surface and the lawn's top
layer of soil being removed.
8 .2

MOWING TIPS

To get the best mowing results, follow the tips
given below.
EN
17