Table of Contents
Advertisement
CAUTIONS
•
Do not open the device enclosure. There are no user serviceable parts inside. Repairs and
servicing should only be performed by an authorised ResMed service agent.
•
Do not use bleach, chlorine, alcohol, or aromatic-based solutions, moisturising or antibacterial
soaps or scented oils to clean the device, humidifier or air tubing. These solutions may cause
damage and reduce the life of these products.
•
Incorrect system setup may result in incorrect mask pressure reading. Ensure the system is
correctly set up.
•
Be careful not to place the device where it can be bumped or where someone is likely to trip
over the power cord.
•
Make sure the area around the device is dry and clean and clear of bedding, clothes or other
objects that could block the air inlet or cover the power supply unit.
•
Ensure that the device is protected against water if used outdoors. Enclose the device in the
S9 travel bag for transport.
Manufacturer: ResMed Pty Ltd 1 Elizabeth Macarthur Drive Bella Vista NSW 2153 Australia. Distributed by: ResMed Corp 9001
Spectrum Center Boulevard San Diego CA 92123 USA.
See www.resmed.com for other ResMed locations worldwide.
For patent information, see www.resmed.com/ip.
S9, H5i, ClimateLine, SlimLine and SmartStart are trademarks of ResMed Pty Ltd and S9, ClimateLine, SlimLine and SmartStart are registered in
U.S. Patent and Trademark Office.
© 2012 ResMed. 368776/2 2012-05
Global leaders in sleep and respiratory medicine
ResMed (UK) Ltd 96 Milton Park Abingdon Oxfordshire OX14 4RY UK.
www.resmed.com
Advertisement
Table of Contents
