Environment; Tools Required; Assembly Procedure - CYBEX Free Weight Weight Tree Owner's Manual

Environment

Humidity and Static Electricity
The unit is designed to function normally in an environment with a relative humidity range of 30% to 75%. The
unit can be shipped and stored in a relative humidity range of 10% to 90%.
Climatic dry air may cause static electricity. During workout, user may experience a shock due to build up of static
electricity on the body and the discharge path of the unit. If static electricity is experienced, increase humidity to
a comfortable level through the use of a humidifier.
Do not install, use or store the unit in an area of high humidity, such as in the vicinity of a steam room, sauna,
indoor pool or outdoors. Exposure to extensive water vapor, chlorine and/or bromine could adversely affect other
parts of the unit.
Temperature
The unit is designed to function normally in an environment with an ambient temperature range of 50° F (10° C)
to 104° F (40° C). The unit can be shipped and stored in an environment with an ambient temperature range of 32°
F (0° C) to 140° F (60° C).

Tools Required

• Rubber mallet
• Flat head screwdriver

Assembly Procedure

Two people will be required for this procedure.
TIP: Read and understand all instructions thoroughly before assembling this unit. Check all items carefully.
If there is damage, see the Customer Service section of this manual for proper procedure to return, replace,
or reorder parts.
Move to desired location
Remove foot glides
Plastic shipping foot glides are used on Cybex Strength Systems machines to protect the bottom of machines
during transportation. These foot glides must be removed before a machine is placed in service, the shipping foot
glides will cause the machine to be unstable.
CAUTION: Remove glides: To avoid serious injury or property damage, remove foot glides before placing
unit in service. If guides are not removed unit will not be stable.
1. Raise the foot of the machine slightly off the floor remove foot glides. Do not install weight plates (if applicable)
until all foot glides have been removed.
2. Loosen each foot glide by striking foot glide with rubber mallet.
3. Pry off foot guide using a flat head screwdriver.
4. Place rubber feet (supplied with machine) on each foot of the frame.
Securely anchor machine to floor
Owner should not allow equipment to be used until it is properly anchored as described below.
Page 8 of 16