Ramsey Electronics FX-440 Manual page 15

the air, keep it wrapped in protective material until you're really
ready to use it.
[ ) 6. The side rails may be installed to the bottom section at any time.
To prevent loss of the screws for the top, keep them loosely
threaded in the side rails.
[ ) 7. There is no point in securing the front panel controls and
jacks to the panel permanently until AFTER wiring the Channel
Selection switch. Note the locking hole for the switch in the front
panel which mates the tab on the front of the switch.
[ ) 8. Use care and a well chosen pair of pliers to secure the
microphone and speaker jacks to the front panel, so as not to
scratch the panel.
[ ) 9. Bend the leads of the TX LED so that their tension presses the
front of the bulb against its front panel hole.
[ ) 10. Whenever you find it necessary to remove the top shell, •store"
the screws back into their holes in the side rails.
[ ) 11. If you decide to install a ribbon cable in the diode matrix for
external programming control, route the cable (folded at a right
angle) on the synthesizer and receiver side of the board so that it
exits the case between the rear panel and top cover, right above
the DC power cord. Do NOT route any such cable across the
VCO and transmitter side.
[ ) 12. After the PC board is secured to the case bottom and fronUrear
panels, it is a good idea to neaten up the wires to the controls and
jacks, bundling them at two or three points with tie wraps or cord.
FX-440
Ref. 13