Ramsey Electronics FX-440 Manual page 132

[ ) [ ) T04. For
+ SM Hz TX
offset, install 3 diodes in the
+
RPT line:
l I
256
()128 [)16
[ ) [ ) T05: Antenna connector (J3):
( ) [ ) Exactly when to install the S0-239 antenna RF connector is left
to your discretion. If you are using the Ramsey CFX case set,
mount the S0-239 to the rear panel as part of this assembly
operation. Use the two screws, nuts, and solder lugs supplied and
consult the illustration as needed. The flange of the connector
sits on the outside of the rear panel. Bend the lugs so that the
jack assembly sits neatly on the PC board. Trim the bare RF
output wire as needed and solder it to the center connector of J3.
This will hold the jack in place for neatly positioning the bent lugs
on the PC board groundplane. Solder both points generously.
Assm. 70
S0-239 CONNECTOR
MOUNTED ON OUTSIDE
OF BACK PANEL
SOLDER HERE
0
FX-440