Ramsey Electronics FX-440 Manual page 14

THE RAMSEY CFX TRANSCEIVER ENCLOSURE KIT
The CFX Kit is very obviously a fair value and solid investment for the
long term performance and worth of your transceiver. As we have
mentioned, we make it "optional" ONLY because some of our ham
customers have specialized applications requiring only the basic PC
board kit. We try whenever we can to accommodate that important
do-it-yourself spirit of ham radio.
ENCLOSURE KIT PARTS LIST
~
11
Steel bottom shell with 5 threaded PC board standoff posts
Steel top shell
1
I I
~
11
~
11
Front control panel
Rear panel with access holes to PC mounted jacks
Steel side rails
PC board standoff spacers
#4 nuts to secure PC board on standoffs
#4 screws to mount front and rear panels
#6 screws for securing top and bottom to side rails
large knob for Channel Selection Switch
smaller knobs for Volume and Squelch controls
self-adhesive rubber feet
CFX CASE ASSEMBLY PROCEDURE:
The purpose of these hardware parts is largely self-evident. We offer the
following suggestions for your convenience and to minimize wear and
tear on your factory-fresh CFX enclosure.
[ ] 1. Since the bottom shell might be used for several "test fittings"
during transceiver assembly, install the rubber feet right away to
protect its finish.
[ ) 2. Obviously, the PC board cannot be secured permanently to the
bottom section until after installation of L9 and L 1 O AFTER
Alignment and before Transmitter tuneup.
[ ] 3. Install the strain-relief grommet supplied with the transceiver kit in
its rear panel hole. Pass the black ground wire through this
grommet. The red, fused wire will have to be unsoldered from S1
and then carefully resoldered after passing through the grommet.
Snap in the locking section of the relief grommet only AFTER both
the red and black wires are in place.
[ ) 4. Remove the two screws from the S0-239 antenna connector,
gently bend the lugs as needed to match the rear panel holes,
then secure the jack and lugs to the rear panel.
[ ) 5. Since the top shell will not be needed until you're ready to go on
Ref. 12
FX-440