Table of Contents
Advertisement
12
dual-conductor
lamp
cord,
took
for the colored thread
molded
in with one
lead.
Decoder Connections
Front amplifier:
Connect
the
recording
outputs
of the front
amplifier
to the FRONT
PREAMP
INPUT jacks, and the FRONT
PREAMP OUTPUT jacks to the tape inputs of the front amplifier.
Back amplifier:
Two pairs of outputs
are provided;
the HIGH
OUTPUT
jacks provide
2 volt output,
and
the
LOW
OUTPUT
jacks provide
500
millivolt
output.
Select
the
output
pair
according
to the sensitivity of your back
amplifier.
The SQD-2020 has tone controls for the back channel.
There-
fore, if you
use an integrated amplifier where
you can
separate
the preamplifier
and power
amplifier sections, connect the SOD-
2020
directly to the power
amplifier section.
If the integrated
amplifier has no power
amp
inputs, connect
the OUTPUT jacks
of the
SQD-2020
to the
tape
or auxiliary
inputs of the back
amplifier.
Record player, Tuner and Auxiliary Sound
Sources
.
Connect
these sources
to the front amplifier as usual.
Suv
records, conventional
two-channel
records,
off-the-air
programs
and auxiliary sources are played through these connections:
Two-channel Tape Recorder
For tape playback, connect the line outputs of the tape recorder
to the 2 CH TAPE RECORDER
TAPE inputs of the SQD-2020.
For tape recording,
connect
the line inputs of the tape recorder
to the
2 CH TAPE RECORDER
REC OUT jacks.
lf your
tape
recorder
has
the same
type DIN 5-pin (indicated
REC/PB)
connector
as that on
the
SQD-2020,
the
record
and
playback
connections
are made
with
a single 5-pin cable, such
as
the
Sony
Connecting
Cord
RC-2
(optional).
When
using
this
DIN
connector,
do
not
make
any
other
input
or output
connections between the SQD-2020 and the tape recorder.
Advertisement
Table of Contents
