Lapierre VISION User Manual page 30

APPENDIX A
• Sides
- Two inner sides of the rear section (E).
o Cover both inside sides of the back with 2 in. (5.08 cm) insulating mat.
o The mat will be held in place, without the use of a fastening mechanism, between the floor and the top
fold of the sides (F), as shown in the image below.
o Follow the instructions in the installation diagrams of your VISION evaporator model. For these instructions,
refer to Appendices B to I.
If your EVAPORATOR is 36 IN. (91.44 CM) WIDE, proceed with the following instructions.
- Three inner sides of the back section (E).
o Cover the three inside sides of the back with 2 in. (5.08 cm) insulating mat.
o The three sides are those located on both sides, as well as the one at the back of the evaporator.
o The mat will be held in place, without the use of a fastening mechanism, between the floor and the top
fold of the side faces (F), as shown in the image above.
o Follow the instructions in the installation diagrams for your VISION evaporator model. For these
instructions, refer to Appendices B to I.
• Wedge
NOTE: Disregard this instruction if you have a VISION
EVAPORATOR with 18 X 48 in., 18 X 60 in. or 24 X 72 in.
accordion pleat type boiling pans.
- As a wedge, at the top of the rear rise (G), place a 1 in.
(2.54 cm) thick strip of insulation mat or insulation
board as shown in the image opposite.
- Follow the instructions in the installation diagrams for
your VISION evaporator model. For these instructions,
refer to Appendices B to I.
Lapierre Equipment |
Installation instructions for insulating materials (continued)
F
VISION EVAPORATOR
G
| USER MANUAL | Version 03 - March 2023
28