5340A Operating Procedures - HP 5340A Operating And Service Manual

Model 5340A
Operation
2
On Rear Panel set INT-EXT switch to INT position.
1.
Set LINE switch to on (up) position.
2.
Set RESOLUTION Hz to desired resolution. Recommended starting setting is
3.
1
DO NOT EXCEED
DAMAGE TO THE INTERNAL SAMPLERS MAY OCCUR. PLEASE READ
PARAGRAPH 3-21 FOR DETAILS OF ACCEPTABLE INPUT LEVELS.
Connect input signal to appropriate input connector according to input fre-
4.
quency and impedance requirements.
5. Set RANGE
6. Adjust SAMPLE RATE control for desired interval between measurements.
Adjust RESOLUTION Hz switch for desired number of significant digits.
7.
Display is in units shown with correct decimal point and significant digits.
8.
3-8
Figure 3-5. 5340A Operating Procedures
8
3 . 7 6
switch correspond with input connector being used.
to
1 5
4