Table of Contents
Advertisement
6 Web Based Graphical User Interface (WebGUI)
Page 19 / 31
6.6.1 Setting IP-address and Web-Service Port
By default, an Industrial DashCam device is configured for getting IP-address via DHCP. It is possible to assign
a static IP-address and the gateway address to the device from the WebGUI. In order to perform this oper-
ation, press the "Set IP Address" button on the "General" tab, see Figure 9. The Set IP Address dialog will
show up. Pay attention to the warnings below the text fields. Enter the IP-address and the gateway address
and press "Set" button. For the changes to take place the Industrial DashCam must be rebooted. This can
be done on the Exit page.
Note, that after changing the IP-address of the Industrial DashCam and rebooting, the WebGUI will be ac-
cessible under different IP-address. Please make sure to update the address in the browser address field.
Accessing the WebGUI by serial number is not affected with change of IP address.
Web service port field specifies the TCP-IP port where the WebGUI is accessible. Default value used by a
browser is 80. If the port is set to any other value, then the port must be specified in the address line after
the IP-address, with a colon as a separation mark. For instance, the port is set to 8945 and the IP-address is
192.152.132.122, then the line entered to access the WebGUI is "192.152.132.122:8945". Additionally,
pay attention to the warning displayed above the text field. In order for the port changes to take place the
application must be restarted.
6.6.2 Language and System Name
In the Language drop-down menu interface language can be chosen, the default value is English. There are
two languages available at the moment: English and German. System name is displayed in the Indicator
panel, see Welcome page chapter. This feature helps to distinguish between the interface of different sys-
tems, when several Industrial DashCams are connected to the same network. Enter desired name into the
"System Name" test field and press "Use" button.
The System name can also be used as overlay on the image, for that make sure the "Show Overlay" check-
box is checked and press the "Use" button. Note, that overlay will only be available on the videos recorded
after the button "Use" is pressed. Already recorded videos though being on the Industrial DashCam's SD-
card remain unchanged.
Finally, the user can reset the counting up number within the naming of the video files by pressing "Reset
video count" on the general configuration page.
6.6.3 Synchronize Time
The "Sync. Time" Button on top of the general tab can be used to synchronize the time between the
browser in use and the Industrial DashCam. This means the local time of the Industrial DashCam will be set
to the time of the browser and thus the system that is used to enter the Web-GUI.
Note: The synchronization of the time will only last until the camera is rebooted or shut down the next
time. After this, the user is required to synchronize the time manually again.
IMAGO Technologies GmbH
Strassheimer Str. 45; 61169 Friedberg; Germany; Tel. +49(0)6031-6842611
info@imago-technologies.com;
www.imago-technologies.com
Advertisement
Table of Contents
