Table of Contents
Advertisement
6 Web Based Graphical User Interface (WebGUI)
Page 17 / 31
Figure 7: Camera parameter dialog
All the settings can be saved or loaded by hovering
button and choosing "Save" or "Load" from
the drop-down menu. The settings are applied only after pressing the "Use" button. Pressing the "Cancel"
or "X" button results in closing the dialog. Further the drop-down offers the possibility to "Load defaults"
for the sensors to setup the camera.
Figure 8: Camera Parameter drop-down
The drop-down menu "Strobe Mode" can be used to select the source for the strobe. "Internal" is to use
the internal LEDs of the Industrial DashCam (S-Mount only), whereas "External" sets up the digital output
0 to send out the exposure signal so an external LED can be triggered. When setting the mode to "Both",
internal LEDs as well as the digital output 0 are set up to be used (Internal still S-Mount only).
IMAGO Technologies GmbH
Strassheimer Str. 45; 61169 Friedberg; Germany; Tel. +49(0)6031-6842611
info@imago-technologies.com;
www.imago-technologies.com
Advertisement
Table of Contents
