Advertisement
Available languages
Available languages
Using the Amp High Back Booster
• Any straps holding the restraint to the vehicle should
be tight, and any straps restraining the child should
be adjusted to the child's body. Straps should not be
twisted.
• DO NOT make any alterations to the child restraint.
DO NOT use accessories or other devices that did not
come with the child restraint.
• DO NOT use this child restraint without the cover. Use
only the cover provided with the child restraint.
• Begin the child restraint installation, in vehicle seat-
ing positions categorized as "Universal" in the vehicle
owner's manual, by using the primary belt route.
• DO NOT use any load bearing contact points other
than those described in the instructions and marked
restraint.
Proper Disposal of this Child Restraint
At the end of this child restraint's useful life, Evenflo
encourages you to dispose of it properly. Most of the
components in this child restraint are recyclable.
1. Remove all fabric and padding.
2. Remove all screws and disassemble the restraint.
3. Recycle all plastic/foam parts and discard the rest.
If your local recycling center won't accept the padding,
you may dispose of it in the landfill.
Note: Evenflo uses recycled materials in the manufacturing
process whenever possible but never for components that
are critical for safety.
14
Using the Amp High Back Booster
9
Child Requirements with Backrest
• 15 – 36 kg
• 96 – 150 cm
• Child is at least three years old or older
Shoulder Belt: Must cross midway between child's
shoulder and neck. Use belt clip, if necessary.
Lap Belt: Stretched low and snug across the child's hips,
beneath the armrests, and fastened into the buckle.
Installation Check Procedure
Place the booster seat on the vehicle seat.
Set the child in the booster seat.
Make sure the child's back and bottom are flat against
the back and bottom surfaces of the booster seat.
Adjust the back of the booster, if necessary.
Adjust the backrest so the shoulder belt guides are level
with the top of the child's shoulders. This will cause
the shoulder belt to properly lay midway between the
child's shoulder and neck.
WARNING
• The shoulder belt
MUST NOT
or fall off the child's shoulder. If you can not adjust
the shoulder belt to properly lay midway between the
child's shoulder and neck, try another seating location
or do not use the booster seat.
•
NEVER
use booster with a lap belt only!
Secure the child and booster seat to the vehicle seat.
Stretch the lap/shoulder belt across the child and fasten
the buckle. Make certain the shoulder belt is threaded
through the shoulder belt guide.
Check your work.
10
11
The shoulder belt must cross the child midway between
his/her shoulder and neck. Make sure the lap belt is
stretched low and snug across the child's hips, beneath
the armrests, and fastened into the buckle.
IMPORTANT: Always secure the booster seat with the
vehicle seat belts when not occupied. An unsecured
booster seat can fly into and injure other occupants in
the event of a crash.
with Backrest
10
11
9
4
cross the child's neck
12
13
15
Advertisement
