Evenflo Amp High Back / No Back Manual page 8

Assembling the Amp High Back Booster
1
1.
Assemble the backrest. Insert three posts on the
headrest into the backrest, as shown. Make certain
the headrest locks securely into the backrest. Note:
This is a one-time assembly and may require
additional force to connect properly.
2
2.
Install pull handle and attach the seat pad. Align
tabs on pull handle with the slots on the back of the
headrest. Press pull handle against the back of the
headrest and slide upward until the tabs lock into
place. Connect seat pad straps to the hooks on
backrest assembly.
3.
3
Install the backrest. Slide the backrest assembly into
the base. Make certain the backrest locks into place.
Check your work.
Inspect the booster seat to make sure that the headrest is
securely attached to the backrest, the seat pad is hooked
into place, and that the backrest assembly is securely
locked into the base. Repeat any assembly steps as
necessary.
12
Adjusting the Amp High Back Booster
4.
4
Adjusting the backrest. To adjust the backrest, pull
and hold the adjustment handle then slide the back-
rest up or down. The backrest is positioned properly
when the bottom of the shoulder belt guides are even
with the top of child's shoulders.
5. 5
Removing the backrest. Lay the booster seat on its
side. Squeeze the lever on the bottom of the base
and remove the backrest from the base.
6.
6
Attaching the shoulder belt clip. Thread the looped
end of the shoulder belt clip belt through the anchor
point on bottom of the booster. Thread the shoulder
belt clip through the loop at the end of the belt and
pull until tight.
7 7.
Storing the instruction manual. After thoroughly
reading and following these instructions, store the
instructions in the slots provided on the bottom of
the booster seat.
8
8.
Using the elastic cup holder:
WARNING
• DO NOT use the cup holder to store cans, bottles, or
hard containers. Only for use with soft cups (such as
styrofoam or paper).
• DO NOT place any cups that contain hot liquids (such
as coffee or tea) in the cup holder.
• DO NOT attach additional padding, toys, or other
devices to the booster seat. Items not tested with the
booster seat could injure the child.
13