Summary of Contents for Evenflo Amp No-Back Booster Seat
Page 1
™ No-Back Booster Seat Owner’s Manual Keep for future use. Child Requirements 18 to 49.8 kg (40 to 110 lbs) 102 to 145 cm (40 to 57 inches) At least four years old d d Para instrucciones en Español, llamar al: 1-800-233-5921 WARNING: To reduce the risk of serious injury or death, read this owner’s manual prior...
When to Put Your Child in a Booster Seat ....8 injury or death. These instructions and the instructions Using the Amp No-back Booster Seat ...... 10 in your vehicle owner’s manual must be followed care- Using the Amp Shoulder Belt Clip ......12 fully.
Consult your vehicle owner’s manual, side air bag, as an expanding air bag may cause the try a different seating location, or call Evenflo for further items to strike your child. assistance.
Visual Glossary Your vehicle may be significantly different than the vehicle Front Seat Lap and pictured. Consult your vehicle owner’s manual to help Shoulder Belts identify your vehicle components. DO NOT place rear-facing child seat on Headrests front seat with air bag. DEATH or Back Seat Headrest in front of SERIOUS INJURY can occur.
When to Put Your Child How can you tell if a child is ready to transition to a booster seat? in a Booster Seat You should consider using a booster seat if the following conditions apply: • The child is mature enough to sit in the booster seat Booster seats raise the child up and help to position the and not put the belts under his/her arm or behind his/ vehicle lap and shoulder belt correctly.
Using the Place the booster seat on the vehicle seat. Set the child in the booster seat. No-back Booster Seat Make sure the child’s back is flat against the vehicle seat, and the child’s bottom is flat against the booster seat.
Using the Amp Shoulder Belt Clip To store the shoulder The use of the shoulder belt clip will depend belt clip harness, fold it on the model of booster seat you have, as and place it in the stor- shown below. age area Model 2 Thread the looped end...
Installing the Amp Seat Pad Using the Elastic Cup Holder Installation of the seat pad will depend on the model of booster seat you have, as shown below. Elastic Cup Holder WARNING DO NOT use the cup holders to store cans, bottles, or Model 1 Model 2 hard containers.
• Take care not to damage any labels. at Evenflo’s option, to repair or replace any Product that is determined to be defective by Evenflo and determined • Machine wash the seat pad separately in cold water, to be covered by this warranty.
Page 11
• USA: 1-800-233-5921 8 AM to 5 PM E.T. • Canada: 1-937-773-3971 • México: 01-800-706-12-00...