Advertisement
7. Install the hoses from the bulkhead to the selector control valve.
A. Move hose
B. Move hose
C. Move hose
D. Move hose
8. Place the 2 abrasion sleeves (24 inches) over the 80-inch and 90-inch hoses and
secure each end with zip ties.
9. Place the large abrasion sleeve (60-inch) over the 2 previous sleeves and secure each
end with zip ties.
10. Connect the 90-inch hose to the lower left connector, port C4, on the selector control
valve.
11. Connect the 80-inch hose to the lower right connector, port C3, on the selector control
valve.
12. Route the 2 houses around the front of the machine to the other side.
Note:
3462-332A
to port C2
to port C1
to port A
to port B
The hoses will be connected in a future step.
.
.
.
.
G435011
G435864
Page 2–10
Installation: Installing the Selector Control Valve
Advertisement
