Advertisement
Installing the Hoses
2
Installing Hoses With or Without the Hydra Borer
Parts Required
1
1
1
1
1
2
1
1
1. Connect the 88-inch hose
2. Connect the 83-inch hose
3. Place the 2 abrasion sleeves (1 X 24 inches) over the 83-inch hose and the 88-inch
hose, secure each end with zip ties.
4. Place the large abrasion sleeve (2 X 60 inches) over the 2 previous sleeves and secure
each end with zip ties.
5. Route the 88-inch and 83-inch hoses down and around the front of the machine.
Note:
Installation: Installing the Hoses
88-inch hose
Hose mount bracket
83-inch hose
26-1/2 inch hose
Hardline (5/8 inch)
Abrasion sleeve (1 X 24 inches)
Abrasion sleeve (2 X 60 inches)
90 degree connector
The hoses will be connected in a future step.
to port T on the on the trencher control valve.
G432651
to port P1 on the trencher control valve.
Page 2–3
3462-332 A
Advertisement
