Table of Contents
Advertisement
18.1 Service and maintenance
This product contains no user serviceable components. Please refer all
maintenance and repair to authorized Raymarine dealers. Unauthorized
repair may affect your warranty.
Warning: High voltage
This product contains high voltage. Do NOT remove covers
or attempt to access internal components, unless specifically
instructed in the documentation provided.
Warning: FCC Warning (Part 15.21)
Changes or modifications to this equipment not expressly
approved in writing by Raymarine Incorporated could violate
compliance with FCC rules and void the user's authority to
operate the equipment.
Caution: Sun covers
• If your product is supplied with a sun cover, to protect
against the damaging effects of ultraviolet (UV) light, always
fit the sun cover when the product is not in use.
• To avoid potential loss, sun covers must be removed when
travelling at high speed, whether in water or when the
vessel is being towed.
Routine equipment checks
It is recommended that you perform the following routine checks, on a
regular basis, to ensure the correct and reliable operation of your equipment:
• Examine all cables for signs of damage or wear and tear.
• Check that all cables are securely connected.
82
18.2 Product cleaning
Best cleaning practices.
When cleaning products:
• Switch off power supply.
• Use a clean damp cloth to wipe clean.
• Do NOT use: abrasive, acidic, ammonia, solvent or other chemical based
cleaning products.
• Do NOT use a jet wash.
Cleaning the display case
The display is a sealed unit and does not require regular cleaning. If it is
necessary to clean the display, follow this basic procedure:
1. Switch off the power to the display.
2. Wipe the case with a clean, lint-free cloth.
3. If necessary, use a mild detergent to remove grease marks.
Cleaning the display screen
A coating is applied to the display screen. This makes it water repellent, and
prevents glare. To avoid damaging this coating, follow this procedure:
1. Switch off the power to the display.
2. Rinse the screen with fresh water to remove all dirt particles and salt
deposits.
3. Allow the screen to dry naturally.
4. If any smears remain, very gently wipe the screen with a clean microfibre
cleaning cloth.
Cleaning the sun cover
The supplied sun cover features an adhesive surface. In certain conditions
unwanted contaminants may stick to this surface. To avoid damaging the
monitor display, clean the sun cover regularly following this procedure:
1. Carefully remove the sun cover from the display.
2. Rinse the sun cover with fresh water to remove all dirt particles and salt
deposits.
3. Allow the sun cover to dry naturally.
Advertisement
Table of Contents
Troubleshooting
