On-Screen Menu - Monitor Audio Anthra Series Product Manual

On-screen menu

Using the encoder and screen on the Anthra amplifier panel you can adjust the volume, low pass
filter and select EQ presets. You can also check for firmware updates if the subwoofer is connected
to the network.
See the opposite page for the menu structure.
Menu
Volume
EQ Presets
Low Pass Filter
Service
Volume
A stepped volume control ranging from -40 - 20 dB.
EQ Presets
Here you can select from a list of three predefined Monitor Audio presets (Music, Movie, Impact)
designed by our audio experts, or three custom presets. These can be created and saved to the
subwoofer using the MaestroUnite app.
Low Pass Filter
By default the Low Pass Filter is disabled, for use with a filtered signal from an AV receiver or
amplfier. If your connection is from a full range source, for example a stereo amplifier, you should
enable the Low Pass Filter to allow only the bass frequencies to be played. Adjustable between 40-
200 Hz.
Service
If your Anthra subwoofer is connected to a network (see MaestroUnite on page 12) you can check
here for firmware updates. You can also put the subwoofer into standby manually.
10
Press to select
Volume
Step Control -40 to 12 dB
Fine Control -6 dB to +6 dB
EQ Presets
Music
Movie
Impact
Custom 1
Custom 2
Custom 3
Low Pass
On/Off
Filter
40 to 200 Hz
Reset
11