Spikes & Feet - Monitor Audio Anthra Series Product Manual

Spikes & feet
Use on wooden or hard floors
The foot comes fully assembled for use on hard floors. All that is required is fixing into the bottom
of the cabinet. This is achieved by simply screwing the feet fully into the 4-threaded inserts in the
underside of the cabinet.
Use on carpeted floors
For carpeted floors, or where spikes are appropriate, the spike can be screwed into the foot
assembly. If your carpet has a very thick pile, remove the soft polymer pad from the foot to
ensure the spike goes all-the-way through the carpet into the floor.
Please ensure there are no hidden wires under the carpet that could be damaged by
the spikes.
Levelling the speaker
Place the cabinet in your desired location, and check that it is level on all sides. If it is slightly
uneven, unscrew the main threaded assembly at the lowest point and check again.
Continue this process until the cabinet is fully level. Use the locking nut on the foot to fix the
foot in place and to stop any unwanted vibrations.
2
M10 x 1.25
M5
3