Changing The Registration Of A Board; Removing The Addireg Program - Addi-Data PA 1508 Technical Description

Chapter 5
In case the registration data is to be modified, it is necessary to boot your PC
again. A message asks you to do so. When it is not necessary you can quit the
ADDIREG program and directly begin with your application.
5.4.3

Changing the registration of a board

IMPORTANT!
To change the registration of a board, you must have administrator rights.
Only an administrator is allowed to register a new board or change a
registration.
• Call up the ADDIREG program. Select the board to be changed.
The board parameters (Base address, DMA channel, ..) are listed in the lower fields.
• Click on the parameter(s) you want to set and open the scroll function(s).
• Select a new value. Activate it with a click.
Repeat the operation for each parameter to be modified.
• Once the wished configuration is set, click on "Set".
• Save the configuration with "Save".
• You can test if the registration is "OK".
This test controls if the registration is right and if the board is present.
If the test has been successfully completed you can quit the ADDIREG program.
The board is initialised with the set parameters and can now be operated.
In case the registration data is to be modified, it is necessary to boot your PC
again. A message asks you to do so. When it is not necessary you can quit the
ADDIREG program and directly begin with your application.
5.4.4

Removing the ADDIREG program

The ADDI_UNINSTAL program is delivered on the CD-ROM.
• Install the ADDI_UNINSTAL program on your computer.
• Start the ADDIREG program and click on "Deinstall registration"
• Quit ADDIREG
• Start the ADDI_UNINSTAL program
• Proceed as indicated until the complete removing of ADDIREG.
You can also download the programm from Internet.
PA 1508
19