PA 1508
Please only use the board:
- in conditions providing absolute security
- in a closed housing which is adequately protected against environmental
influences
- with the accessories we recommend.
The use of the board according to its intended purpose includes observing every
advice given in this manual and in the safety leaflet.
Uses beyond these specifications are not allowed. The manufacturer is not liable
for any damages which would result from the non-observance of this clause.
1.1
Limits of use
The board PA 1508 is not to be used for securing emergency stop functions.
No emergency stop functions are to be controlled through the output channels.
The board must not operate in a PC which does not provide for an adequate
protection against environmental conditions (e.g.: liquids, dust, ...) and which is
not equipped with an appropriate aeration system.
Make sure that your PC is equipped with a safety system and a shielded metal
housing.
The installation of the board in sites lying under risk of explosion is excluded.
The board should not be submitted to vibrations without additional fixation.
WARNING!
The EMC tests have been carried out in a specific appliance
configuration. We guarantee these limit values only in this configuration.
The tested appliance configuration is at your disposal on request.
The use of the board in a PC could change the PC features regarding noise
emission and immunity. Increased noise emission or decreased noise immunity
could result in the system not being conform anymore.
Please control that the PC-housing and the cable are effectively shielded before
putting the device into operation.
Make sure that the board remains in its protective blister pack until it is used.
Do not remove or alter the identification numbers of the board. If you do, the
guarantee expires.
2
Chapter 1
Need help?
Do you have a question about the PA 1508 and is the answer not in the manual?
Questions and answers