Table of Contents
Advertisement
= 1. Installation location
Note the following points when installing the stereoscopic
microscope.
e Install the microscope in a location with the temperature between
0° and 40°C, and humidity of less than 80%. If installed in a hot
and humid location, mold may form on the lenses or condensation
may occur inside, resulting in reduced performance or damage to
the microscope.
e Do not install the microscope in a location subject to direct
sunlight.
Install the microscope in a location that is not subject to vibration.
e Install the microscope in a location that is free from dust and dirt.
. Handle the microscope carefully |
The stereoscopic microscope is a precision optical instrument.
Handle it carefully and do not subject it to impact. Shock from
impact during transportation or operation as well as forcible
operations may cause damage to the instrument.
. Cleaning the lenses
Do not let dust, fingerprints, etc. to get on the lenses. Dirt on the
lenses will adversely affect the view of the image. If any lenses
become dirty, clean them as described below.
e Use an air blower to blow dust away. If this does not suffice, brush
away the dust with a soft brush or gently wipe it away with a piece
of gauze.
e Only if the lenses become dirty with fingerprints or grease stains,
slightly dampen a piece of soft, clean cotton cloth with absolute
alcohol (ethyl alcohol or methyl alcohol) and gently wipe away the
dirt. Do not use the same part of the cloth more than once.
e Since absolute alcohol is highly flammable, be careful in handling
it so that it does not ignite.
e Observe the manufacturer's handling instructions when handling
absolute alcohol.
Advertisement
Table of Contents
