Table of Contents
Advertisement
rm Power supplies
Use the Power Supply XN for regions using 100/120 V power, and the
Power Supply TN-PSE30 for regions using 230 V power. Insert the plug
of the Halogen illuminator into the output connector located on the rear of
the power supply.
Input voltage display
Check that the voltage displayed matches the
Fuse
voltage used in your area. If the voltages do
SS
not match, do not use the power supply and
Always use the fuse
contact your Nikon representative.
specified.
(Rear view)
Power cord
Output connector |
Power switch
ge;
Connect the
J
2
lamphouse cable here.
Brightness adjuster
Changes the illumination brightness when rotated.
Power Supply XN (only for regions with 100/120 V power)
Input voltage display
4
s
Check that the voltage displayed
Brightness adjuster
matches the voltage used in your area.
If the voltages do not match, do not use
the power supply and contact your
Nikon representative.
Changes the illumination
brightness when rotated.
(ad
(Rear view)
|
Output
|
Power switch
connector _|
Connect the
lamphouse cable here.
Power cord
AC input connector
Connect the specified power
cord here.
Power Supply TN-PSE30 (only for regions with 230 V power)
Advertisement
Table of Contents
