Table of Contents
Advertisement
Screw the objective into the bottom of
- ~
the zooming body.
As
Mount the eyepiece tube.
-
Align the groove on the eyepiece tube with
the positioning pin on the zooming body, push
the eyepiece tube toward the back to attach.
Tighten it to the zooming body using the
clamp tool.
Groove
g Insert the eyepieces into the eyepiece sleeves.
Be sure that it is inserted all the way until it touches the end of the sleeve.
Note) When inserting the eyepiece, hold the rubber cover of the eyepiece.
Holding the diopter ring causes a failure. Especially, be careful
with the
10X eyepieces because their rubber covers obstruct the
view of the sleeve end.
LE The clamp tool can be stored in the pillar of the stand.
Refer to the figures on p.9.
Advertisement
Table of Contents
