Beko SLGR 30524SS Owner's Manual page 55

INSTALLATION
TEST FOR GAS LEAKS
Warning: Never check for leaks with a
!
flame. Do not continue to the next step
until all leaks are eliminated.
Warning: Before you plug in an electrical
!
cord, be sure all controls are in the OFF
position.
• Leak testing shall be conducted by the
installer according to the instructions
given in this section.
• Turn on Gas. Apply a non-corrosive leak
detec-tion fluid to all joints and fittings in
the gas con-nection between the shut-off
valve and the range. Include gas fittings
and joints in the range if connections
may have been disturbed during
installation. Bubbles appearing around
fittings and connections indicate a leak.
• If a leak appears, turn off supply line gas
shut-off valve and tighten connections.
Re-test for leaks by turning on the supply
line gas shut-off valve. When leak check
is complete (no bubbles appear), test
is complete. Wipe off all detection fluid
residue.
Test Burner Function
Warning: Verify that wiring in house is
!
correctly installed. If not call Service.
1. Turn on Power at Breaker
Test Rangetop Burners
• Test Burner Ignition. Select a range top
burner knob. Push down and turn to the
flame symbol. The igniter/spark module
will produce a clicking sound. Once the
air has been purged from the supply
lines, the burner should light within four
(4) seconds.
• Test Flame: High Setting. Turn burner
on to HI. See for appropriate flame
characteristics. If any of the burners
continue to burn mostly or com-pletely
yellow, call Service.
• Test Flame: Low Setting. Turn burner on
to L.O. Verify that the flame completely
surrounds the burner. There should be
a flame at each burner port and there
should be no air gap between the flame
and the burner. If any of the burners do
not carry over, call Service.
• Test the ignition and flame of each range
top burner as described above.
• When flame is properly adjusted there
should be a flame at each range top
burner port.
Test Oven Burners
• Open the oven door. Remove the two
front thumb screws of oven bottom
cover, slide cover forward and out.
Remove the reflector cover forward and
out.
Test Bake Burner Ignition
• Set the oven to bake at 350° F. After
30-75 seconds, the burner will ignite.
The burner will stay lit until the 350° F
is reached and then shut off. From this
point forward, the burner will cycle on
and off to maintain the temperature.
Test Bake Burner Flame
• While the burner is lit, inspect the flame.
See below flame figures for proper
flame characteristics. If the flame burns
completely or mostly yellow, adjust the
bake burner air shutter. See below flame
figures (next page) for details.
Test Broil Burner Ignition
• Set cooking mode to Hi Broil. The burner
will ignite after 30-75 seconds.
Test Broil Burner Flame
• While the burner is lit, inspect the flame.
See below flame figures for proper
flame characteristics. If the flame burns
completely or mostly yellow, adjust the
broil burner air shutter. See below flame
figures for details. Replace the reflector
cover and oven bottom cover. Fix the
cover withtwo rear thumb screws.
23