Beko SLGR 30524SS Owner's Manual page 52

INSTALLATION
• When installed where it is not permitted
to ground through the neutral, a
4-conductor cord must be used or
cable assembly. See manufacturer's
instructions.
• The main supply data must correspond
to the data specified on the rating label
of the appliance. The rating plate is either
seen when the door is opened.
• To minimize possible shock hazard,
the cord must be plugged into a mating
3-prong ground-type outlet, grounded
to conform with the Na-tional Electrical
Code, ANSI/NFPA 70 latest edition, or
Canadian Electrical Code (CSA) and all
local codes and ordinances. Refer to the
illustration below.
20
Electrical Grounding Instructions
Warning: The appliance is equipped
!
with a three-prong (grounding) plug for
your protection against electrical shock
hazard and should be plugged directly
into a properly grounded three-prong
recep-tacle. Do not cut or remove the
grounding prong from the plug.
Warning: For gas fired 120 VAC units
!
and any NEC compliant receptacle,
proper ground and correct polarity is
required. Electric convection ovens are
configured at the factory for operation
from 208 VAC, single phase, or 208
VAC, three-phase electrical service is
also an available configuration. Consult
wiring diagram located at the end of
this manual and on the back side of the
appliance.
Warning: Risk of electric shock, short
!
circuit or fire by damage of the main
power supply! The main power supply
lead must not be clamped, bent or
trapped or come into contact with
hot parts of the appliance. If the main
power supply is damaged, it must be
replaced by a qualified electrician.
Caution: The gas cooker requires
!
a 110/120VAC electrical supply to
operate the elec-tronic ignition system.
The 6' (1.8 m) power supply cord
provided with the range is equipped
with a 3-prong, grounded plug for
protection against shock hazard. The
service should have its own 15 amp
circuit breaker.