Troubleshooting Table; Accessories / Spare Parts; Technical Data - Gardena EasyCut 110/18V P4A Operator's Manual

4. Clean the lopper, the battery and the battery charger
(see 4. MAINTENANCE).
5. Store the lopper, the battery and the battery charger in a dry, enclosed
and frost-free place.
6. TROUBLESHOOTING
DANGER!
Cutting injury due to the blade!
Risk of cut injury due to accidental starting.
v Use gloves.
v Remove the battery.
v Slide the protective cover over the blade.

6.1 Troubleshooting table:

Problem Possible Cause
Start lever cannot Start lever is stuck.
be pushed
Lopper does not start Battery is empty.
or stops.
(L1)
LED blinks green
[ Fig. O4 ]
Lopper does not start Battery temperature is outside
or stops. the permissible temperature
(Wp)
Error-LED lights red range.
[ Fig. O4 ]
There are drops of water or
moisture between the battery
contacts.
Obstacle blocks the motor.
Lopper does not start Lopper is defective.
or stops.
Error-LED (Wp) blinks red
[ Fig. O4 ]
Lopper does not start
Battery is not put completely
or stops. into the battery holder.
Error-LED (Wp) does not
light [ Fig. O4 ]
Battery is defective.
Lopper is defective.
Charging is not possible.
Battery is not slid onto the
Battery charge indicator (Lc) charger correctly.
lights continuously green
Battery contacts are dirty.
[ Fig. O3 ]
Battery temperature is outside
the permissible temperature
range.
Battery is defective.
Charging is not possible. Mains plug of the charger is
(Lc)
Battery charge indicator not plugged in correctly.
does not light
Mains socket, mains cable or
[ Fig. O3 ]
charger is defective.
NOTE:
Repairs must only be done by the GARDENA service departments or
specialist dealers approved by GARDENA.
v For any other malfunctions please contact the GARDENA service
department.

7. TECHNICAL DATA

Lopper Unit
Max. branch diameter mm
14772-56.960.01.indd 7 14772-56.960.01.indd 7
Remedy
v Loosen the start lever.
v Charge the battery.
v Wait until the battery
temperature is between
0 °C – 35 °C again.
v Remove the water drops or
moisture with a dry cloth.
v Remove the obstacle.
v Contact the GARDENA
Service.
v Put the battery completely
into the battery holder until
it audibly engages.
v Replace the battery.
v Contact the GARDENA Service.
v Slide the battery onto the
charger correctly.
v Clean the battery contacts
(e. g. by connecting and dis-
connecting the battery several
times. Replace the battery if
necessary.
v Wait until the battery
temperature is between
0 °C – + 35 °C again.
v Replace the battery.
v Insert the mains plug com-
pletely into the mains socket.
v Check the mains voltage.
Let the charger be checked
if necessary by an authorised
specialist dealer or the
GARDENA Service.
Value Value Value
(Art. 14772) (Art. 14774) (Art. 14776)
28 28 28
Lopper Unit
Max. cuts per battery charge
PBA 18V 2.0Ah W-B
PBA 18V 2.5Ah W-B
PBA 18V 3.0Ah W-B
PBA 18V 4.0Ah W-C
PBA 18V 5.0Ah W-C
PBA 18V 6.0Ah W-C
Range of extension of
cm
the telescopic tube
Max. Height (with telescopic
cm
tube extended)
Weight (without Battery) kg
Sound pressure level L
1)
dB (A)
pA
Uncertainty k
pA
Sound power level L :
2)
WA
measured/guaranteed
dB (A)
Uncertainty k
WA
Hand/arm vibration a
1)
m/s
2
vhw
Uncertainty k
vhw
Measuring process complying with: EN IEC 62841-4-2
1)
NOTE: The stated vibration emission value has been measured according to
a standardised test procedure and can be used for comparison of one electric
power tool with another. It can also be used for preliminary evaluation of
exposure. The vibration emission value can vary during actual use of the electric power
tool depending on the ways in which the machine is used. As a safety measure, you
should work with the machine for a maximum of 1 hour without interruption.

8. ACCESSORIES / SPARE PARTS

GARDENA Extension tube To extend Art. 14774 or as
a replacement.
GARDENA Protective cover To protect the batteries from moisture.
for Power+ batteries
GARDENA System Battery Battery for additional duration or for
P4A PBA 18V/45 replacement.
P4A PBA 18V/72
GARDENA Battery Quick Charger for fast charging the POWER FOR
Charger AL 1830 CV P4A ALL System Batteries PBA 18V..W-..
9. SERVICE
Please contact the address on the enclosed warranty card.
10. DISPOSAL
10.1 Disposal of the lopper:
(according to Directive 2012/19/EU / S.I. 2013 No. 3113)
The product must not be disposed of to normal household
waste. It must be disposed of in line with local environmental
regulations.
IMPORTANT!
v Dispose of the product through or via your local recycling collection
centre.
10.2 Disposal of the battery:
The battery contains lithium-ion cells that should not be
disposed of with normal household waste at the end of its life.
Li-ion
IMPORTANT!
1. Discharge the lithium-ion cells completely (contact the GARDENA
Service).
2. Protect the contacts on the lithium-ion cells against short circuits.
3. Dispose of the lithium-ion cells properly via or through your local
recycling collection centre.
Value Value Value
(Art. 14772) (Art. 14774) (Art. 14776)
400 400 400
500 500 500
600 600 600
800 800 800
1000 1000 1000
1200 1200 1200
– 215 – 255 320 – 360
110 255 360
1.9 3.4 4.1
65 63 57
3 3 3
76 / 79 77 / 80 77 / 80
3 3 3
≤ 2.5 ≤ 2.5 ≤ 2.5
1.5 1.5 1.5
RL 2000/14/EC / S.I. 2001/1701
2)
Art. 14772-20.630.00
available via GARDENA
Service
Art. 14800-00.600.36
available via GARDENA
Service
Art. 14903
Art. 14905
Art. 14901
01.08.23 08:59 01.08.23 08:59
7